---
title: "Induction zone and coil repair"
description: "One zone dead while the others work, which on induction is better news than it sounds: the problem is usually local to that zone's coil or to its section of"
url: "https://askomiami.support/services/induction-zone-and-coil-repair/"
date_modified: "2026-09-13"
Appliance type: "Cooktops"
---


# Asko induction zone and coil repair

### One dead zone is local hardware, and that is good news

A single zone out while the others work implicates that zone's coil or its section of the generator board and clears the supply, the main control and the touch panel in one observation. Two adjacent zones failing together means something different — they usually share a board section — so the pattern is established across every zone before the glass is disturbed, since lifting a top is the expensive way to find out. Bridge and link settings are checked first because they move a zone's power silently and produce an identical symptom for nothing.

What this involves

One dead zone implicates its own coil, not the hob's supply

Bridge and link settings can move power silently and look like a failure

Glass lifted only after the electrical reading says it has to be

Test the zone against its neighbors

Each zone under the same load, so the pattern is established. A pattern of two adjacent zones means something different from one on its own.

Read the coil and its section

Coil resistance and the board's driver stage for that zone, measured before the glass is disturbed.

Replace and re-test all zones

Because a repair to one zone that upsets another is worth finding today rather than hearing about next week.

### Will the whole hob need replacing?

Rarely. Coils and board sections are serviceable parts. What decides it on this badge is availability, because no hob is in the US catalog and the components come from Europe — and we establish that before quoting rather than after.

### Can the glass be lifted without breaking it?

Yes, and it is done only once the electrical reading says it has to be. A top sealed into stone needs the seal cut properly rather than levered, which is part of why the figure is what it is.

---

**[Read full article: Induction zone and coil repair](https://askomiami.support/services/induction-zone-and-coil-repair/)**