---
title: "Dryer will not start"
description: "A machine that does nothing at all, and as with the dishwasher the first suspect is the door rather than the electronics: a dryer will not run with the door"
url: "https://askomiami.support/symptoms/dryer-will-not-start/"
date_modified: "2026-09-13"
Appliance type: "Dryers"
---


# Asko dryer will not start

### What to do in the next ten minutes

Push the door firmly shut and try again. Empty the water container and seat it fully. Cut the power at the socket, wait five clear minutes, restore it. Then note whether the panel lights at all — that single observation splits this complaint in half and it is the first thing we will ask you.

### Why a dryer checks so much before it runs

Door, container, temperature and sometimes filter state are all interlocked, because a dryer that starts with any of them wrong is a dryer that either spills water or overheats. The consequence for the owner is that a machine which will not start is usually being sensible rather than broken, and that the cheap checks genuinely are the likely ones. It is the opposite of most appliances, where silence means something serious.

### What the reset actually does

Five minutes off at the wall clears a control that has latched an old condition and not released it — a container that was full, a cut-out that has since cooled. It is not a repair and it should not be a routine: a machine that needs resetting every week has a real problem underneath, and the reset is hiding it rather than fixing it.

The door is not latching

A catch that has worn or a door that has dropped. It has usually needed a firmer push for weeks before it stops working altogether.

The water container is full or unseated

The machine will not begin a cycle it cannot finish, and it says so in whichever code family that board uses.

There is no power, or the control has failed

A dark panel with a proven live socket is the expensive end. It is reached last, and only after the supply itself has been measured at the machine.

Does the panel light?

Illuminated but inert points at the door, the container or the program chosen. Nothing lit at all means supply or control.

Is there a child lock on?

Every model has one, and wiping the panel down sets it more often than anyone admits.

Does anything else on that circuit work?

A laundry closet often shares a breaker with the washer. If both are dead, the machine is not the problem.

Nothing happens when the program is selected

What it usually means

Push the door until it latches — a worn catch produces this exactly

A full or unseated water container stops the machine before it begins

An unlit panel and a lit one that ignores you are two separate problems

What to do in the next ten minutes

Push the door firmly shut and try again. Empty the water container and seat it fully. Cut the power at the socket, wait five clear minutes, restore it. Then note whether the panel lights at all — that single observation splits this complaint in half and it is the first thing we will ask you.

Why a dryer checks so much before it runs

Door, container, temperature and sometimes filter state are all interlocked, because a dryer that starts with any of them wrong is a dryer that either spills water or overheats. The consequence for the owner is that a machine which will not start is usually being sensible rather than broken, and that the cheap checks genuinely are the likely ones. It is the opposite of most appliances, where silence means something serious.

What the reset actually does

Five minutes off at the wall clears a control that has latched an old condition and not released it — a container that was full, a cut-out that has since cooled. It is not a repair and it should not be a routine: a machine that needs resetting every week has a real problem underneath, and the reset is hiding it rather than fixing it.

### It started after I opened and closed the door twice.

That is the door catch, plainly. It will get worse and the part is small.

### Should I check the breaker?

Yes, and check it properly — off and fully on rather than a glance. A breaker that has tripped part way looks closed and passes nothing.

---

**[Read full article: Dryer will not start](https://askomiami.support/symptoms/dryer-will-not-start/)**