- “Lights working proves the supply and halves the diagnosis”
- “Touch strips fail from daily cleaning, and they are an ordinary part”
- “The wrong lamp type destroys its own holder in a concealed liner”
Symptom
Asko hood lamps work but the fan does not
Lamps lit and the motor silent, which is more useful than it sounds: on almost every hood the lamps and the motor sit on different circuits after the switch, so lights working proves the supply is fine and points the whole diagnosis away from it. What is left is the switch or touch strip, the motor and its capacitor. On the concealed liners this make is known for, the touch strip is the common failure in a kitchen where the hood is wiped down every day.
- From $95 diagnostic, credited to the repair
- 59 cities and neighborhoods covered
- OEM parts available on order
- In writing the price, before anything is opened
Three ordinary causes
What this usually turns out to be
Cheapest and commonest first, which is also the order we check them in. They sit hundreds of dollars apart, and only the unit settles which one is yours.
-
The touch strip or switch has failed
Common where the hood is cleaned daily, and a straightforward part. It reads as a speed problem rather than a control one, which is why the speeds are tried in turn.
Hood light and control service from $119 -
The motor or its capacitor
A hum with no rotation points here. Measured for current draw and bearing play rather than replaced on a sound.
Range hood motor and blower service from $165 -
Something is jammed in the impeller
Rare and worth ruling out, because a motor straining against a jam draws wrongly and looks electrically dead.
Hood liner service from $175
In five minutes
Before you call anybody
None of it needs tools, and all of it makes the visit shorter.
-
01
Do the lamps work?
If they do, the supply is proven and the problem is after the switch. That is the whole value of this observation.
-
02
Does it hum?
A hum with no movement is mechanical or a capacitor. Silence is the switch or the control.
-
03
Is the panel wet?
A touch strip with water on it behaves exactly like a failed one. Dry it and try again before assuming anything.
How it shows up
What people describe when they call
In more detail
About Asko hood lamps work but the fan does not
What to do in the next ten minutes
Try every speed in turn and listen — a hood that hums at the highest setting and does nothing at the lowest is telling a different story from one that is silent throughout. Wipe the control area dry and try again, because a wet touch strip behaves like a broken one. Then switch the circuit off for a minute and back on.
Why a concealed liner costs more to reach
These are built to disappear into somebody else's millwork, often with no service access at all. Getting to one is joinery as much as appliance work, and we say before the visit what will have to come off — and we do not open a cabinet we cannot put back to the same standard.
The lamp detail worth knowing
Lamp type, wattage and holder are matched to the liner. The wrong lamp fitted into a concealed hood runs hot enough to destroy the holder it sits in, which turns a two-minute job into a part and a visit. If the lamps have been changed recently and one has failed again quickly, that is usually why.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards
Before you book
Questions about Asko hood lamps work but the fan does not
Can I change the lamps myself?
Generally yes, and it is worth matching the type exactly rather than fitting whatever is at hand — a concealed liner runs hotter than an open one.
It works on one speed only.
That is the control rather than the motor, and it is the cheaper of the two. Worth saying on the phone.
Where we do it
Across Miami-Dade, Broward, and Palm Beach
Same terms everywhere we go: an on-site diagnostic first, the price agreed in writing, and the exact figure confirmed once we have seen the unit.
Neighborhoods people ask for by name